Embedding Molds

These capsules, made from polyethylene, produce blocks with a 5,6mm outer diameter and a pyramid tip. Comes complete with a hinged cap.

The bottle neck capsule produces a 7,9mm outer diameter block with a hemihyperpoloid (rather than faced) tip.

The conical capsule produces a 7,9mm outer diameter block with a conical (rather than faced) tip

Polyethylene embedding capsules with 1x1mm face at the tip of a truncated pyramid, each with a hinged cap. Inner diameter 8mm.

Molded from polyethylene. The critical surfaces of the mold are transparent, facilitating accurate specimen orientation through bottom illumination. Molds are reusable and each mold is supplied with a protective box.

Set of one body and one row of cone caps. Body diameter is 8mm. Head is 2mm. Body (G69934-8B) and cone cap base (G69934-8C) are also available individually. A cone cap base can be used as air tight seal as well.

***Ask for Samples***

The five interconnected conical caps form the basis of the embedding mold. Diameter of the head: 2mm.

***Ask for Samples***

Each body piece consists of 5 numbered cavities, each with a diameter of 8mm. This body part plus the cone cap base (G69934-8C) give one row of 5 embedding molds.

***Ask for Samples***